1

Warm-up status

After installation, power on the detector and the buzzer beeps for power

Audible to indicate that the power supply is on. The detector enters the preheating state of the gas-sensitive element, the power supply

The green LED flashes and after about 120 seconds the gas-sensitive element warms up and the power supply is green

The LED is solid on.

2

Monitor the status

After the warm-up state is over, the power supply green LED is solid and the detector enters normal

Monitor the status.

3

Alarm status

When the detector detects a methane (CH4) leak that reaches the alarm threshold, it is repeated several times

After the judgment of the buzzer issued a discontinuous alarm code, the alarm red indicator light is solid on, enter

Alarm status.

When the gas concentration drops below the alarm threshold, the detector is judged by many times

The action resumes to the normal monitoring state.

4

Failure status

When the sensor fails (such as a fault, a broken circuit, etc.), the fault is yellow

The alarm indicator light is flashing, indicating that there is a fault, such as the fault can not be eliminated in time

Multiple times to judge the buzzer to issue a continuous beep code, the fault yellow indicator light is solid on, enter

Enter the fault alarm state.

After the fault is lifted, the detector automatically returns to normal monitoring after multiple judgments

State.

5

Sensor failure status

When the detector detects that the sensor has reached the age of the sensor failure,

The life indicator flashes, indicating that the user has failed the sensor and needs to be replaced in time

Utensil.

6

Self-test status

When the detector's self-test button is pressed, the life indicator flashes and the alarm points red

The light is on and the buzzer beeps (at this point, if the self-test button is pressed again, it is reported.)

The alarm starts the linkage function, and then the linkage signal is output between the 7S-30S and the relay touches

Point switching, hit the valve line to output a low pressure pulse signal), followed by a fault yellow indicator

On, the buzzer emits a fault tone, and finally the detector returns to normal monitoring state.

Note: In order to ensure the normal operation of the product, during the 120s of the product power preheating

Please do not press the self-test key!

7

Data reporting

There are two ways to report data:

1. Magnetic departure report data: the magnet trigger is greater than 2s, and the red light is lit

2. Regular active reporting data: the timing reporting period and the timing reporting time can be set, the value range of the timing reporting period is 600~86400S, and the regular reporting time value range is 0~23H. After setting, the reporting time is calculated according to the metered DeviceEui, the timing reporting period, and the timing reporting time. timing

The default value of the reporting period is 86400S.

8

Read probe status and status alerts

Support gas detector status reading, read every 10s; The detector status changes immediately on the alarm data:

Reporting data (hexadecimal)

24 1922 16839E27ED 1401 1B04 1203 0B00000000 1A0053 330000 2300 C1

24: Frame head 19: Packet number 16: Device (table number) 14: Pulse constant 1B: Device type 12: Mode

1A: Voltage 33: Status Word 23: Trigger Source C1: Cumulative Sum

Status words:

B15=1: Warm-up

B13=1: Sensor end-of-life

B11=1: Device status acquisition failed

B7 = 1: Alarm status

B6 = 1: Failure status

9

Wireless setting parameters

Parameters can be set in two ways:

1. Wireless far-field setting parameters: After the detector completes the information report, it can be realized through the cloud platform.

2. Wireless near-field setting parameters: realized through production setting tools. The Near Field parameter is set to Wireless Communication Mode.